Huawei Quidway S3100 Series User Manual

Operation Manual – 802.1x
Quidway S3100 Series Ethernet Switches Chapter 1
802.1x Configuration
Huawei Technologies Proprietary
1-19
1.5.5 Configuring Guest VLAN
Table 1-6 Configure Guest VLAN
Operation Command Description
Enter system view
system-view
—
Configure port
access method
dot1x port-method
{ macbased | portbased }
Optional
The default port access
method is
MAC-address-based. That is,
the macbased keyword is
used by default.
Enable the Guest
VLAN function
dot1x guest-vlan vlan-id
[ interface interface-list ]
Required
By default, the Guest VLAN
function is disabled.
Caution:
z The Guest VLAN function is available only when the switch operates in a port-based
authentication mode.
z Only one Guest VLAN can be configured for each switch.
z Supplicant systems that are not authenticated, fail to pass the authentication, or are
offline belong to Guest VLANs.
z The Guest VLAN function is not available to switches that are configured not to
authenticate users that use static IP addresses (refer to the dot1x dhcp-launch
command). (Because switches of this type do not send active authentication
packets.)
1.6 Displaying and Debugging 802.1x
You can verify the 802.1x-related configuration by executing the display command in
any view.
You can clear 802.1x-related statistics information by executing the reset command in
user view.

Huawei Quidway S3100 Series Specifications

General

Brand	Huawei
Model	Quidway S3100 Series
Category	Switch
Language	English