Operation Manual – NTP
Quidway S3100 Series Ethernet Switches Chapter 1
NTP Configuration
Huawei Technologies Proprietary
1-19
# Enter system view.
<Quidway3> system-view
System View: return to User View with Ctrl+Z.
[Quidway3]
# Enter VLAN interface view.
[Quidway3] interface Vlan-interface 2
# Configure Quidway3 to be a multicast server.
[Quidway3-Vlan-Interface2] ntp-service multicast-server
2) Configure S3100-1.
# Enter system view.
<S3100-1> system-view
System View: return to User View with Ctrl+Z.
[S3100-1]
# Enter VLAN interface view.
[S3100-1] interface Vlan-interface 2
# Configure Quidway4 to be a multicast client.
[S3100-1-Vlan-Interface2] ntp-service multicast-client
3) Configure S3100-2.
# Enter system view.
<S3100-2> system-view
System View: return to User View with Ctrl+Z.
[S3100-2]
# Enter VLAN interface view.
[S3100-2] interface Vlan-interface 2
# Configure Quidway1 to be a multicast client.
[S3100-2-Vlan-Interface2] ntp-service multicast-client
The above configuration configures S3100-1 and S3100-2 to listen multicast packets
through their VLAN interface 2, and Quidway3 to advertise multicast packets through
VLAN interface 2. Because S3100-2 does not resides in the same network segment as
Quidway3 does, the former cannot receive multicast packets sent by Quidway3, while
S3100-1 is synchronized to Quidway3 after receiving multicast packets sent by
Quidway3.
Display the status of S3100-1 after the synchronization.
[S3100-1] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 3.0.1.31
To Next Page
Loading...
Need help?
General