Juniper EX9214 Hardware Guide

EX9200 Network Cable and Transceiver Planning
IN THIS SECTION
Pluggable Transceivers Supported on EX9200 Switches | 137
Overview of EX Series Switches: Fiber-Opc Cable Signal Loss, Aenuaon, and Dispersion | 138
Calculate the Fiber-Opc Cable Power Budget for EX Series Devices | 140
Calculang the Fiber-Opc Cable Power Margin for EX Series Devices | 140
Pluggable Transceivers Supported on EX9200 Switches
The line cards in EX9200 switches support 1-gigabit Ethernet small form-factor pluggable (SFP), 1-
gigabit Fast Ethernet SFP, 10-gigabit small form-factor pluggable plus (SFP+), 40-gigabit quad small
form-factor pluggable plus (QSFP+), and 100-gigabit C form-factor pluggable (CFP) transceivers.
• You can nd the list of transceivers supported on EX9204 switches and informaon about those
transceivers at the Hardware Compability Tool page for EX9204.
• You can nd the list of transceivers supported on EX9208 switches and informaon about those
transceivers at the Hardware Compability Tool page for EX9208.
• You can nd the list of transceivers supported on EX9214 switches and informaon about those
transceivers at the Hardware Compability Tool page for EX9214.
NOTE: We recommend that you use only opcal transceivers and opcal connectors purchased
from Juniper Networks with your Juniper Networks device.
CAUTION: The Juniper Networks Technical Assistance Center (JTAC) provides
complete support for Juniper-supplied opcal modules and cables. However, JTAC does
not provide support for third-party opcal modules and cables that are not qualied or
supplied by Juniper Networks. If you face a problem running a Juniper device that uses
third-party opcal modules or cables, JTAC may help you diagnose host-related issues if
the observed issue is not, in the opinion of JTAC, related to the use of the third-party
137

Juniper EX9214 Specifications

General

Brand	Juniper
Model	EX9214
Category	Switch
Language	English