Juniper EX9214 Hardware Guide

NOTE: Because a line card is heavy, and because anstac bags are fragile, inserng the line card
into the bag is best done with two people, each to do one of the following steps.
To insert a line card into an anstac bag:
1. Hold the line card in the horizontal posion with the faceplate facing you.
2. Slide the opening of the bag over the line card connector edge.
If you must insert the line card into a bag by yourself:
1. Lay the line card horizontally on a at, stable surface, sheet metal side down.
2. Orient the line card with the faceplate facing you.
3. Carefully insert the line card connector edge into the opening of the bag and pull the bag toward you
to cover the line card.
Maintaining Line Card Cables
Components in the line cards are fragile. To extend the lives of your line card cables and to avoid
problems that can result from cable damage, follow these procedures:
To maintain line card cables:
• Place excess cable out of the way. Do not allow fastened loops of cable to dangle from the
connector. Placing fasteners on the loops helps retain their shape.
• Keep the cable connecons clean and free of dust and other parcles, which can cause drops in the
received power level. Always inspect cables and clean them if necessary before connecng a port.
• Label both ends of line card cables to idenfy them.
Unpacking a Line Card Used in an EX9200 Switch
Before you unpack a line card:
• Ensure that you have taken the necessary precauons to prevent electrostac discharge (ESD)
damage (see Prevenon of Electrostac Discharge Damage ).
• Ensure that you know how to handle and store the line card (see Handling and Storing Line Cards ).
250

Juniper EX9214 Specifications

General

Brand	Juniper
Model	EX9214
Category	Switch
Language	English