Juniper EX9214 Hardware Guide

Packing an EX9200 Switch or Component
IN THIS SECTION
Packing an EX9200 Switch | 327
Packing EX9200 Switch Components for Shipping | 328
If you are returning an EX9200 switch or component to Juniper Networks for repair or replacement,
pack the item as described in this topic.
Before you begin packing the switch or component, ensure you have:
• Followed all the steps listed in Contact Customer Support to Obtain Return Material Authorizaon .
• Retrieved the original shipping carton and packing materials. Contact your JTAC representave if you
do not have these materials, to learn about approved packing materials. See
Contact Customer
Support to Obtain Return Material Authorizaon .
• Ensure you understand how to prevent electrostac discharge (ESD) damage. See Prevenon of
Electrostac Discharge Damage .
Ensure that you have the following parts and tools available:
• An ESD wrist strap
Packing an EX9200 Switch
If you need to transport the switch to another locaon or return the switch to Juniper Networks, you
need to pack the switch securely in its original packaging to prevent damage during transportaon.
To pack the switch for shipment:
1. Retrieve the shipping crate and packing materials in which the switch was originally shipped. If you
do not have these materials, contact your Juniper Networks representave about approved
packaging materials.
2. On the console or other management device connected to the primary Roung Engine, enter CLI
operaonal mode and issue the following command to shut down the switch soware. (If two
Roung Engine modules are installed, also issue the command on the backup Roung Engine.)
user@switch> request system halt
327

Juniper EX9214 Specifications

General

Brand	Juniper
Model	EX9214
Category	Switch
Language	English