To Next Page

To Previous Page

9.4.14 Restart communicaon

The following parameter can be used to restart or stop communicaon. Oponally it is also

possible to reset all communicaon parameters to the default status.

Details

A restart of communicaon is required aer changes of the interface conguraon (e. g. node

address and baud rate) in order that the changed sengs become eecve.

For restarng communicaon, there are two opons:

Switch inverter o and on again.

Set the selecon = "Restart with current values [1]" in 0x2300 (P508.00).

Parameter Name / value range / [default seng] Info

0x2300

(P508.00)

CANopen communicaon

(CANopen comm.)

•

Seng can only be changed if the inverter is inhibi-

ted.

Restart / stop communicaon.

•

Aer successful execuon, the value 0 is shown.

0 No acon/no error Only status feedback

1 Restart with current values Restart communicaon with the current values.

2 Restart with default values Restart communicaon with the standard values of the CAN parameters

(0x1000 ... 0x1FFF and 0x2301).

5 Stop network communicaon Stop communicaon.

•

The "Stop Remote Node" NMT command is executed. Aer successful

execuon of this command, only the recepon of network manage-

ment frames is possible.

10 In progress Only status feedback

11 Acon cancelled

12 Error

Conguring the network

CANopen

Restart communicaon

278

Lenze i55AE155F User Manual

Other manuals for Lenze i55AE155F