Lenze i55AE155F User Manual

9.11.9 Short setup
In the following, the steps required for controlling the inverter via POWERLINK are described.
Parameterisaon required
1.
Acvate network control: 0x2631:037 (P400.37) = "TRUE [1]"
2.
Set network as standard setpoint source: 0x2860:001 (P201.01) = "Network [5]"
3.
Set the node address.
•
Each network node must be provided with a unique node address (node ID).
•
Details: 4Basic sengs ^ 397
4.
Save parameter sengs: 0x2022:003 (P700.03) = "On / start [1]".
5.
Switch the inverter o and then on again in order that the changed communicaon set-
tings can get eecve.
6.
Check the readiness for
operaon of the inverter by means of the LED status displays.
•
The red LEDs must be o, otherwise an error has occurred.
•
The green LED at the RJ45 socket is on if a physical POWERLINK connecon is available.
•
Details: 4LED status displays ^ 398
In the default seng, the digital input DI1 is assigned with the "Run" funcon. If
the network control is acvated, this funcon serves as "start enable" for start
commands via network. Hence, the digital input DI1 must be set to HIGH level in
order that the motor can be started via network. 4Start / stop motor ^ 531
Start network
The network is automacally started if you rst set all controlled nodes (as described above)
and then the managing node.
Otherwise, there are the following two opons:
a)
Switch all network nodes o and then on again or
b)
make a fault reset at the managing node (node ID 240).
Conguring the network
POWERLINK
Short setup
406

Lenze i55AE155F Specifications

General

Brand	Lenze
Model	i55AE155F
Category	Inverter
Language	English