Lenze i55AE155F User Manual

9.11.3 LED status displays
Informaon on the network status can be obtained quickly via the "BS" and "BE" LED displays
on the front of the inverter. In addion, the LEDs at the RJ45 sockets indicate the POWERLINK
connecon status.
The meaning can be seen from the table below.
LED "BS" (green) NMT communicaon status Meaning
o - The network opon is not supplied with voltage, is not acve at the net-
work or is in the INIT state.
Flashing
NMT_CS_PREOPERATIONAL_1 The POWERLINK network is in the inialisaon phase.
Flashing 2 x
NMT_CS_PREOPERATIONAL_2 The POWERLINK network is in the inialisaon phase with cyclic trac.
Flashing 3 x
NMT_CS_READY_TO_OPERATE The network opon waits for the start signal.
ickers
NMT_CS_BASIC_ETHERNET The network opon has not found a managing node and is in the "Basic
Ethernet Mode".
blinking
NMT_CS_STOPPED The network opon is in the "Stopped" state (waing for switch-o).
on
NMT_CS_OPERATIONAL The network opon is in the operang phase.
LED "BE" (red) Status/meaning
on
POWERLINK network error
Status displays at the RJ45 sockets
The LEDs at the RJ45 sockets display the POWERLINK connecon status:
LED "A" (green) Status/meaning
o No POWERLINK connecon.
on
A physical POWERLINK connecon is available.
ickers
Data is exchanged via POWERLINK.
LED "B" (red) Status/meaning
on
POWERLINK collision
Status displays at the RJ45 sockets
The LEDs at the RJ45 sockets indicate the connecon status to the network:
LED "A" (green) Status/meaning
o No connecon to the network.
on
A physical connecon to the network is available.
ickers
Data is exchanged via the network.
LED "B" (red) Status/meaning
on
POWERLINK collision
Conguring the network
POWERLINK
LED status displays
398

Lenze i55AE155F Specifications

General

Brand	Lenze
Model	i55AE155F
Category	Inverter
Language	English