To Next Page

To Previous Page

9.5.10 Restart communicaon

The following parameter can be used to restart communicaon.

Details

A restart of communicaon is required aer changes of the interface conguraon (e. g. node

address and baud rate) in order that the changed sengs become eecve.

For restarng communicaon, there are two opons:

Switch inverter o and on again.

Set the selecon = "Restart with current values [1]" in 0x2320 (P508.00).

Parameter Name / value range / [default seng] Info

0x2320

(P508.00)

Modbus communicaon

(Modbus comm.)

1 = restart communicaon in order that changed sengs of the interface

conguraon become eecve.

0 No acon/no error

1 Restart with current values

9.5.11 Response me seng

Dene a minimum me delay between the recepon of a valid Modbus message and the

response of the inverter.

Especially at higher baud rates, dening a minimum me delay ensures the data exchange

between transmier (Modbus master) and receiver (e. g. inverter).

Parameter Name / value range / [default seng] Info

0x2321:004

(P510.04)

Modbus sengs: Minimum response me

(Modbus se.: Min. resp. me)

0 ... [0] ... 1000 ms

Conguring the network

Modbus RTU

Response me seng

291

Lenze i55AE155F User Manual

Other manuals for Lenze i55AE155F