Starting/stopping the engine – for driving
4.1 Starting the engine – from the driver's cab
Operating manual 3 302 819 en 4 - 13
GMK3060
13.12.2018
Without flame
start system
If the engine is equipped with a flame start system; Ã With flame start system,
p. 4 - 14.
This section pertains to starting a warm and cold engine.
• Wait until the start menu is displayed before switching on the ignition.
• Do not press the accelerator.
• Turn the ignition key to position 3 and hold it there until the engine starts.
• Release the ignition key after the engine starts.
If the engine does not start, release the ignition key after about 15 seconds and
wait one minute before trying again.
H
If the engine does not start after several attempts; Ã Engine malfunctions,
p. 8 - 19.
s
S
Danger of explosion when using starter fuel!
The engine may never be started with the aid of starter fuel. The starter fuel
sprayed into the intake manifold can ignite.
S
Risk of malfunctions in the carrier electronics!
Always wait until the start menu is displayed before starting the engine. This pre-
vents malfunctions in the electronics and corresponding error messages in the
subsequent driving operation.
To Next Page
Loading...
Need help?
General
