Driving mode
5.3 Driving and parking the truck crane
5 - 44 3 302 819 en Operating manual
GMK3060
13.12.2018
5.3.4 Driving uphill
Starting The engine must be running.
To start moving forwards you must do the following:
– Shift into D position
– Apply the parking brake
– Press the accelerator
– Release the parking brake after the clutch has engaged
If the CL warning appears when starting:
• Remove your foot from the accelerator immediately and apply the service
brake. For the subsequent procedure;
à Warning message when starting,
p. 5 - 30.
To start reversing you must do the following:
– Shift into position R
– Release the parking and service brakes
– Apply the accelerator if you wish to accelerate
– Do not apply the accelerator if you wish to brake with the engine.
Driving On certain gradients, the transmission may switch continuously back and forth
between two gears. In this event, either release the accelerator slightly or
downshift by one gear.
G
Danger of the truck crane starting to roll away unexpectedly!
When starting to move forwards, always keep the truck crane stationary with the
parking brake until the transmission is engaged. If the truck crane starts to roll
away before this (when changing from brake pedal to accelerator), no gear will
be engaged, and you can stop the truck crane only by braking.
To Next Page
Loading...
Need help?
General
