Malfunctions in driving mode
8.6 Tilting/lowering the driver's cab
Operating manual 3 302 819 en 8 - 39
GMK3060
13.12.2018
8.6 Tilting/lowering the driver's cab
To tilt the driver's cab (e.g. for maintenance work), the main boom must be raised
and the hoisting gear moved.
This assumes that the engine can be started.
H
If the engine cannot be started, you must use the hydraulic emergency operation
to lift the main boom;
à p. 14 - 51.
8.6.1 Prerequisites and information on tilting
Before tilting the driver's cab, the following requirements must be met:
– The truck crane must be level.
– All loose objects must be removed from the driver's cab!
– The main boom is raised to the extent (about 1.5 m (4.9 ft)) that the driver's cab
will not touch the main boom (nor the hose drum) when tilting!
– Ensure that the hook block is outside the driver's cab slewing range and the
windscreen.
S
Risk of damage to the steering's universal joint!
The steering wheel may only be moved when the driver's cab is lowered and
locked. When moving the steering wheel into other driver's cab positions,
the steering's universal joint can be damaged.
To Next Page
Loading...
Need help?
General
