Rigging work
12.8 Other rigging work
12 - 106 3 302 819 en Operating manual
GMK3060
13.12.2018
12.8.2 Cameras for crane operation
Camera on
main boom
For crane operation you have to install the camera and switch it on.
For on-road driving, you have to switch the camera off again and remove it.
The transmitter (1) and the associated receiver
(2) are matched to each other and are identified
by the same number on the model plates.
Neither the transmitter nor the receiver should be
removed or installed; they remain together on the
truck crane at all times.
In the event of a defect, both transmitter and
receiver must always be replaced, even if only
one part is defective. When spare parts are
ordered both transmitter and receiver are always
delivered together.
• Switch off the ignition in the crane cab
G
Risk of accidents if an incorrect transmitter or receiver is used
In the event of a defect, do not under any circumstances use a transmitter or
receiver from another truck crane.
This is to avoid the wrong image appearing on the monitor of your crane or the
monitor of a neighbouring crane.
To Next Page
Loading...
Need help?
General
