Manitowoc GROVE GMK3060 User Manual

Malfunctions in driving mode
8.4 Troubleshooting
Operating manual 3 302 819 en 8 - 19
GMK3060
13.12.2018
8.4 Troubleshooting
8.4.1 Engine malfunctions
H
In addition to this information; à Separate engine manufacturer's operating manual.
.
Malfunction Cause Solution
Engine does not start –
Starter does not turn
Battery master switch is
switched off
Switch on the battery
master switch;
à p. 4 - 9
Switch the ignition off
à Switching the ignition on,
p. 4 - 9
Transmission not in neutral
position
à Switching the transmis-
sion to the neutral position,
p. 5 - 26
Parking brake released Apply the parking brake;
à p. 5 - 52
Fuse F1/1, F1/2 blown Replace blown fuses;
à p. 8 - 43
Emergency stop switch pressed Reset emergency stop
switch;
à p. 4 - 20
Engine does not start –
Starter turns
Batteries insufficiently charged Charge the batteries;
à Maintenance manual
The lamp does not light
after the ignition is
switched on when the
engine is cold
Fuse F6/8 blown Replace blown fuses;
à p. 8 - 43
The truck crane drives at
a maximum of 20 km/h
(12 mph)
A locking procedure is not yet
completed
Lock the differential locks or
steering
Coolant temperature too
hot – the symbol is
displayed.
Coolant level too low Top up coolant;
à Maintenance manual
Oil level in the transmission
too low
Check the oil level;
à Maintenance manual
Outer surface of heat exchanger
dirty
Clean the heat exchanger
V-belt of coolant pump at engine
loose
Tighten V-belt;
à Separate engine manufac-
turer's operating manual
s

Manitowoc GROVE GMK3060 Specifications

General

Brand	Manitowoc
Model	GROVE GMK3060
Category	Construction Equipment
Language	English