Rigging work
12.5 Operating the outriggers
12 - 48 3 302 819 en Operating manual
GMK3060
13.12.2018
12.5.11 Outrigger pressure display
H
Especially with asymmetrical outrigger spans, the outrigger pressure displays do
not provide useful information on correct alignment. Horizontal alignment is the
decisive factor for correctly supporting the truck crane;
à p. 12 - 43.
After switching on the ignition, the outrigger pressure displays indicate the current
outrigger pressure for all supporting cylinders. The value shown has an accuracy
of ±10%, therefore the value specified in the outrigger pressure table always
determines the load on the ground.
The set unit (t or klbs) is shown next to the displays.
H
Outrigger cylinders retracted or extended as far as possible will lead to an
incorrect outrigger pressure display.
The display will show the most accurate reading if the movement performed last
was Extend outrigger cylinders.
In the Outrigger menu
The assignment of the displays to the carrier is
given by the directional indicator (1).
G
Risk of accidents when misused!
A displayed outrigger pressure over 0 t does nor guarantee protection against
overturning or overloading. For this reason, never override the RCL.
2 Front left outrigger pressure
3 Front right outrigger pressure
4 Rear left outrigger pressure
5 Rear right outrigger pressure
To Next Page
Loading...
Need help?
General
