Crane operation
11.6 Settings and displays for crane operation
Operating manual 3 302 819 en 11 - 133
GMK3060
13.12.2018
11.6.6 Setting the characteristic curves for the control levers
The control lever characteristic curve determines how high the power unit speed
should be for a particular control lever movement.
You can assign different control lever characteristic curves to the power units.
• Open the Settings menu (1).
The symbols (2) show the set characteristic
curves of the power units (1).
• Select the power unit for which you would like
to change the characteristic curve.
• Set the desired characteristic curve.
Select and confirm symbol (3) to reset all power
units to characteristic curve 1.
There are five characteristic curves:
The higher the number of the characteristic
curve (1) to (5), the further the control lever
must be moved to get a clear increase in speed.
When the characteristic curve (5) is set, you can
work particularly sensitively with the control lever.
To Next Page
Loading...
Need help?
General
