Crane operation
11.3 MAXbase slewing range type
11 - 32 3 302 819 en Operating manual
GMK3060
13.12.2018
11.3.3 Lifting capacities and slewing ranges for outrigger spans
without separate lifting capacity tables
In the case of outrigger spans where the opposing outrigger beams at the right
and left sides are extended to different lengths, Lifting capacity tables are only
available for combinations where the outrigger span at the right side is greater
than at the left side. This applies to two types of outrigger spans.
Outrigger span type Three / One
Lifting capacity tables are only provided for the combination One outrigger span
smaller – left, e.g. for the outrigger span (
I).
Outrigger span type Right / left
Lifting capacity tables are only provided for the combination Right greater than left,
e.g. for the outrigger span (
II).
When the truck crane is on outrigger beams with a mirrored outrigger span then
the same lifting capacities are enabled in the correspondingly mirrored slewing
range.
Example
Assuming that the truck crane is on outrigger
beams with the outrigger span (III) and a load is
to be lifted in the slewing range To the right (1).
Since the outrigger span at the left side is greater
than at the right side, the
Lifting capacity table for
the mirrored outrigger span (II) with the mirrored
slewing range
To the left (2) must be used.
The loads specified for the slewing range (2) are
enabled in the slewing range (
1) for the outrigger
span (III).
To Next Page
Loading...
Need help?
General
