Driving modes
6.2 Weighing the truck crane
Operating manual 3 302 819 en 6 - 7
GMK3060
13.12.2018
6.2 Weighing the truck crane
Weighing error The most precise method for determining the total weight of the GMK3060 is to
use calibrated scales of appropriate capacity and a weighbridge on which all the
wheels of the truck crane can stand at the same time.
All other weighing procedures are subject to various factors which can lead to
weighing errors. This Operating manual describes a procedure by which the
greatest number of sources of weighing errors can be avoided. Also observe all
the instructions provided by the manufacturer of the scales.
If multiple individual scales are used, allowance must be made for the fact that
the axle groups are hydraulically coupled. For this purpose, you will need wheel
load scales of sufficient capacity and size.
– Determining the total weight
The weights of all the axle groups belonging to
the crane must be recorded at the same time in
a single weighing procedure. In addition, only
one set of scales may be used per axle group
on each side of the vehicle. The GMK3060 has
two coupled axle groups (A1 to A2) and you will
require four wheel load scales (W1 to W4).
s
a
Defective measurement of the axle loads and total weight!
When determining the axle loads and total weight, do not use individual dial
scales. If individual dial scales are used to weigh a truck crane, this will lead to
incorrect, unreliable measurement results.
To Next Page
Loading...
Need help?
General
