Transport
7.1 Transport with transport vehicle
Operating manual 3 302 819 en 7 - 1
GMK3060
13.12.2018
7 Transport
Transport should be carried out only by qualified heavy transport companies
whose personnel are well-acquainted with loads of these dimensions and
weights.
7.1 Transport with transport vehicle
• Note the dimensions and weight of the truck crane for the transport;
à Dimensions and weights of the truck crane, axle loads, p. 1 - 8.
G
Risk of accidents due to improper transport!
Assign transportation to only qualified companies and ensure that the regula-
tions applicable in the country in which you are working are adhered to.
G
Risk of accidents due to improper means of transport!
Use only suitable lifting gear with sufficient lifting capacity for loading.
Use only trailers and vehicles with sufficient loading surface and load bearing
capacity for transport.
G
Risk of accidents due to inadequate information!
Observe the information in the following sections concerning transport. You can
thus prevent unsecured parts from falling or components from being damaged
due to improper handling.
G
Risk of accidents!
Using only a suitable ramp of sufficient load bearing capacity. The ramp
inclination must not be greater than 15°.
If the inclination is too steep, unwanted motion of the vehicle may occur. This can
cause the truck crane to tip off the ramp. This can cause serious injuries to
yourself and other people.
G
Risk of accidents due to falling parts!
Use only suitable lifting gear with sufficient load bearing capacity and use only
the slinging points and lashing points provided.
To Next Page
Loading...
Need help?
General
