Crane operation
11.4 Operation of the rated capacity limiter
Operating manual 3 302 819 en 11 - 45
GMK3060
13.12.2018
11.4.4 Confirming the rigging mode and lifting capacity table
You must confirm the rigging mode together with the display lifting capacity table
before commencing crane operation. Some parts of the procedure are different,
depending on the entered slewing range type.
Slewing range
type Standard
If the MAXbase slewing range type has been entered;
à p. 11 - 47.
• Check that the current rigging mode of the truck crane corresponds to the
displayed rigging mode.
• Check:
• Correct any incorrectly entered rigging modes if
necessary.
The displayed lifting capacity table (9) applies to
the RCL code (5) in the corresponding slewing
range (8) and for the preselected telescope
status (7).
If the actual rigging mode is displayed correctly
and the planned operation can be performed
within the displayed working range (8) then you
can confirm the rigging mode.
s
G
Risk of accidents due to an incorrectly set RCL!
If the current rigging mode varies from the displayed rigging mode, the maximum
load displayed by the RCLwill not correspond to the actually permissible lifting
capacity according to the Lifting capacity table.
Overloading and accidents will certainly be the result.
–1 The slewing range for the planned job
–2 The rigged outrigger span
–3 The rigged counterweight
–4 The rigged boom system
–6 The number of reeved hoist rope lines
To Next Page
Loading...
Need help?
General
