Driving mode
5.2 Operating the transmission
Operating manual 3 302 819 en 5 - 31
GMK3060
13.12.2018
Transmission malfunctions and errors shown on
the displays (1);
à Warning and malfunction messages on the
instrument panel, p. 8 - 3,
à Warning messages on the driving mode display,
p. 8 - 8,
à Warning messages on the CCS display, p. 8 - 10,
à Error messages on the CCS display, p. 8 - 16.
5.2.6 Driving and changing gears
•
When driving, always leave the switch in the position for the current driving
direction, e.g. in position D for forward travel.
In Automatic
operating mode
In this operating mode, the transmission changes to the gear suitable for the
current load, engine speed and position of the accelerator.
Automatic upshifting
You can influence upshifting by using the accelerator.
s
G
Risk of accidents due to changing transmission direction whilst driving!
If whilst driving in one direction you select a gear for the opposite direction,
the transmission shifts into the neutral position. In this position, you cannot
accelerate the truck crane, even in an emergency, and the engine retarder
does not work.
– Pressing the accelerator slightly: Upshifting at low engine speed
– Pressing the accelerator harder: Upshifting at high engine speed
To Next Page
Loading...
Need help?
General
