Starting/switching off the engine – for crane operation
10.2 Starting the engine – from the crane cab
Operating manual 3 302 819 en 10 - 5
GMK3060
13.12.2018
10.2.4 Control lever deflection query
This section applies only to the control lever ver-
sion with symbols on the instrument panels (2).
When the ignition is switched on, a query appears
asking if both control levers are at their initial posi-
tions.
When at the initial position
The menu with the symbols (1) is displayed briefly
then the Start menu opens.
When the control levers are actuated
(A) – The symbol (3) is displayed, e.g. for the left
control lever.
• Move both control levers to their initial
positions.
(B) – Repeat the query
• Select and confirm the symbol (2).
The symbols (1) are displayed briefly then the
Start menu opens.
H
If the start menu is not displayed, you can switch off the ignition and then switch
it on again with both control levers at their initial positions.
To Next Page
Loading...
Need help?
General
