Crane operation
11.7 Working range limiter
Operating manual 3 302 819 en 11 - 137
GMK3060
13.12.2018
11.7 Working range limiter
You can set and monitor different limits in the working range limiter menus:
– A maximum overall height
– A maximum working radius
– A maximum slewing angle
– A limited hoist rope travel
The monitoring of the programmed limits can be switched on and off separately.
After switching on the ignition, all monitoring functions are switched on that were
on before the ignition was turned off.
G
Risk of accidents due to situations which cannot be monitored!
The working range limiter only serves as an additional safety device. Brake the
crane movement before contact with the obstacle becomes imminent. Do not
deliberately move into the shutdown range. You, the crane operator, are still
responsible for monitoring the working range, so that you can react appropriately
if situations arise which cannot be monitored electronically.
G
Risk of accidents due to limits set too low!
When entering the limit values, bear in mind that, even after switching off the
engine, movements can still occur that would bring the load into the shutdown
area, e.g. due to the load swinging or the boom bending. For this reason, always
enter the limit values with sufficient safe distance to the object.
G
Risk of accidents due to insufficient safe distances!
Always observe all safe distances in accordance with the national legal regula-
tions (for example, concerning overhead power lines) even if the working range
limiter is switched on.
To Next Page
Loading...
Need help?
General
