Driving modes
6.1 Driving modes
6 - 2 3 302 819 en Operating manual
GMK3060
13.12.2018
6.1.1 Information on how to use the tables
H
This section only shows some standard driving modes. For further information on
additional or individual driving modes, please contact
Manitowoc Crane Care.
The tables consist of two parts:
– The driving mode of your truck crane is specified in the top part, next to
Equipment. Find out which driving mode applies to your truck crane.
– The required rigging mode for this driving mode and the accessories you are
allowed to transport are specified in the lower section, next to Rigging mode.
Example of how to use the table:
Assume your truck crane is equipped with 385/95 tyres, 6 x 4 x 6 drive.
Equipped with a retarder and towbar coupling.
In this case the driving mode in the upper part, next to equipment, is 4.
According to the specifications in the lower part, in addition to rigging mode,
– the 3-sheave hook block may be attached to the front bumper,
– the 15 m lattice extension may be folded to the side and
– a 7.6 t counterweight may be installed on the turntable.
Additional parts must be transported on a separate vehicle
H
If you remove indicated parts from the truck crane in driving mode, then the total
weight decreases but might be distributed in such a way that the front or rear axle
loads are over 12 t.
To Next Page
Loading...
Need help?
General
