Rigging work
12.5 Operating the outriggers
Operating manual 3 302 819 en 12 - 43
GMK3060
13.12.2018
12.5.9 Levelling the truck crane on outriggers horizontally
You must level the truck crane horizontally before crane operation and possibly
correct its horizontal alignment during crane operation.
Inclination
indicators
After switching on the ignition, various inclination indicators display the current
alignment.
Switching between measuring ranges
You can change the measuring range between
1° and 5°.
• Press the button (2) once.
The current measuring range (1) is displayed.
The measuring range is automatically switched in
the Outrigger menu and the Monitoring menu.
Read the display
Only the lamp (1) at the centre is on if the truck
crane is level.
The other lamps show the sides of the truck crane
which are higher.
– RCL / CCS display
The assignment to the carrier is given by the
directional indicator (1).
In this example, the carrier would be standing
higher to the rear on the right hand side.
s
A In the Monitoring menu
B In the Outrigger menu
C On the Outrigger control units
To Next Page
Loading...
Need help?
General
