Malfunctions during crane operation
14.4 Troubleshooting
14 - 26 3 302 819 en Operating manual
GMK3060
13.12.2018
14.4.16 Malfunctions on the CraneSTAR system
If an error is present, then check the fuses and the electronic connections.
Checking
• Loosen the bolts (2) and remove the cover (1).
• Check the associated fuse on the plate (3) and
replace it if necessary:
à Fuses in the crane
cab, p. 14 - 71.
• Loosen the screws (4) and fold down the
plate (3) to the front.
S
Risk of damage if procedure is incorrect!
Observe the following notes to avoid malfunctions and damage.
– Always switch the ignition off before changing a fuse and before checking the
antenna plugs.
– Replace blown fuses only with new fuses of the same amperage.
To Next Page
Loading...
Need help?
General
