Driving mode
5.1 Before driving
5 - 18 3 302 819 en Operating manual
GMK3060
13.12.2018
5.1.5 Setting the tachograph
Diagram sheets (24-hour discs) can be inserted into the tachograph for two driv-
ers simultaneously.
As a crane operator, you are obligated to set each activity on the tachograph.
H
This section only describes the basic operation of the tachograph (inserting
diagram sheets, setting time groups, operating errors).
Before operation, also note the information in the tachograph
manufacturer's separate operating manual.
There you will find detailed information (marking the diagram sheets,
malfunctions, etc.).
Prerequisites To set the tachograph, the following requirements must be met:
– The ignition is switched on.
– The truck crane must be stationary.
– No error message is displayed.
In the event of
malfunctions
Check that a malfunction has occurred.
In the case of a Tachograph malfunction
–lamp (2) lights up,
–the display (1) shows an error message.
à Separate operating manual the Tachograph
manufacturer.
S
Risk of damage to the tachograph drawer!
Open the tachograph drawer only to insert or remove diagram sheets and do not
use the opened drawer as a shelf or surface (e.g. to mark the diagram sheets).
This prevents contamination and damage.
To Next Page
Loading...
Need help?
General
