Driving mode
5.1 Before driving
Operating manual 3 302 819 en 5 - 19
GMK3060
13.12.2018
Setting the
tachograph
To set the tachograph, you must first open the drawer and check the time setting.
You can then insert the diagram sheets and set the time groups.
Opening the drawer
• Press the button (6) once.
First the symbol (5) and the running bar (4)
appear, then the drawer (3) opens.
• Pull out the drawer (3) as far as it will go.
The diagram sheet mounting (2) and an isolating
plate (1) are in the drawer.
Checking the time setting
• First check the time setting for the diagram
sheet mounting (2); fold the isolating plate (1)
upwards to do this.
• Insert a diagram sheet. Make sure that the
diagram sheet is under the spring (4).
• Check whether the diagram sheet's time scale
on the marking (3) is showing the current time.
Correcting the time
• Take all the diagram sheets out of the diagram sheet mounting.
• Close the drawer.
The time setting is corrected automatically.
• Open the drawer and insert the required diagram sheets.
s
To Next Page
Loading...
Need help?
General
