Driving with a rigged truck crane
13.5 Driving from the crane cab
13 - 26 3 302 819 en Operating manual
GMK3060
13.12.2018
13.5.6 Possible connections
The telescoping cylinder and the telescopic section cannot be unlocked
simultaneously.
You can make the following connections, one
after the other:
– Longitudinal differential locks (2)
– Transverse differential locks (1).
The symbols indicate the current switching state.
Longitudinal/
transverse
differential locks
With a 6 x 6 x 6 drive, the drive of the 1st axle line is switched on and off together
with the longitudinal differential locks.
Straighten the steering.
• Stop the truck crane.
For switching on and off, the current speed needs to be under approx. 5 km/h
(3 mph).
S
Risk of damage to the differential locks!
Leave the transverse differential locks switched on only for as long as necessary.
Always switch off the transverse differential locks before driving on a firm
surface!
To Next Page
Loading...
Need help?
General
