Driving mode
5.2 Operating the transmission
5 - 28 3 302 819 en Operating manual
GMK3060
13.12.2018
For reverse travel
The reversing camera and the reversing lamp are switched on.
The display (1) shows the area behind the truck crane.
When you exit the transmission mode R, the reversing lamp and camera are
switched off and the display (1) shows the CCS menu.
Selecting the
starting gear
You can also change the gear that is automatically selected on starting.
H
Only change the gear selected on starting if it is absolutely necessary to do so.
Starting is a gear that is too high causes premature clutch wear.
• Press the gearshift lever forwards once.
The starting gear is shifted up by one gear.
• Press the gearshift lever backwards once.
The starting gear is shifted down by one gear.
The altered starting gear is shown on the display.
By changing the starting gear, you also change the transmission over to Manual
operating mode at the same time. For on-road driving, you should switch over to
Automatic operating mode.
To Next Page
Loading...
Need help?
General
