Malfunctions in driving mode
8.5 Emergency operation and breakdown assistance
8 - 34 3 302 819 en Operating manual
GMK3060
13.12.2018
On the spare
wheel holder
When changing a wheel, you must remove the spare wheel from the spare wheel
holder and mount the damaged wheel on to the spare wheel holder.
You can use a chain hoist or the truck crane to lift the wheel.
• If you lift the wheel with the truck crane, then:
– Support the truck crane and
– Enter and confirm the current rigging mode.
• Lift the spare wheel using only lifting gear with sufficient load bearing capacity;
à Spare wheel, p. 1 - 10.
Third brake light
If there is a third brake light, then you have to remove it before removing the
wheel from the spare wheel holder. Before driving on the road, the brake light
must be reattached.
– Removing
• (A) – Remove the nuts (2).
• (B) – Fit the brake light (1) into the holder.
• Undo the nuts (2).
– Installation
• (B) – Remove the nuts (2).
• (A) – Fit the brake light (1) onto the holder (3).
• Secure the brake light with the nuts (2).
G
Danger of overturning if the truck crane is free-standing!
Always support the truck crane on outriggers before rotating the superstructure.
Never operate the truck crane in the Free on wheels operating position if the tyres
are damaged.
G
Risk of overturning while slewing!
Always check before slewing whether slewing is permitted in the truck crane's
current rigging mode (counterweight, outrigger span, working radius).
Correct the rigging mode if necessary;
à Slewing with a rigged counterweight,
p. 12 - 76.
To Next Page
Loading...
Need help?
General
