82
Program the Radio’s
Codeplug (Requires
RIB)
From the MAIN MENU, press F3 and then F8 to bring up this screen.
This screen allows you to program the radio. A radio interface box (RIB)
is required to perform this operation. If the programming process is
successfully completed, you will see the following message: “Radio
Was Successfully Programmed”. You will then be returned to the GET/
SAVE/PROGRAM screen automatically.
Programming Steps:
Trunking Radios Only
If you do not have the necessary System Key files and are programming
a radio, the serial number of the attached radio must be identical to
the one in the serial number field on the RSS and the PROGRAMMING
HISTORY screen (F3/F9). To program a radio, you must first read its
codeplug information by pressing F2 on the GET/SAVE/PROGRAM
MENU. A radio and RIB must be properly connected to the computer and the
power turned on before any attempt is made to program the radio’s codeplug.
Note: If the serial numbers of the “source” codeplug and the
“target” radio are different, programming will be aborted.
Field Definition
Programming Codeplug Blocks This is the number of blocks that have been programmed. The status
bar shows a relative value of the number of blocks programmed so far
compared to the total number of blocks to be programmed.
CH
MOTOROLA Radio Service Software
MCS Model:
MAIN:GET/SAVE/PROG:READ RADIO
PROGRAM RADIO CODEPLUG
----------------------
Programming Codeplug Block 1 of 34
0% 100%
|----+----+----+----+----+----+----+----+----+----+----+----|
F1 F2 F3 F4 F5 F6 F7 F8 F9 F10
To Next Page
Loading...
Need help?
General