Oki MC363dnw Advanced Manual

- 141 -
5. Fax
This section describes the scan settings for Internet Fax transmissions.
If using Scan to Fax Server, the following scan settings are not available.
• Setting a reply destination
• Editing an e-mail
• Specifying a file name (file name)
• Scanning a duplex document (duplex scan)
Scanning Multiple Documents Continuously (Continuous Scan)
You can scan a fax transmission document from the ADF and document glass. For example,
you can send a document and a part of a book as a single fax job.
1
Press the (FAX) button on the operator panel.
2
Set a document in the ADF or on the document glass.
3
Press the button to select [Internet Fax] and press the button.
4
Press the or button to select [Continuous Scan] and press the
button.
5
Press the or button to select [ON] and press the (OK) button.
6
Specify a destination.
Entering a Destination E-mail Address
Specifying a Destination from Address Book/Group List
Selecting a Destination Using One Touch Buttons
Selecting a Destination from Transmission History
Searching for a Destination in the LDAP Server
7
Press the (MONO) button to start scanning the first document.
8
When [Please set next document] is displayed, set the next document.
9
Check that [Start Scan] is selected, and then press the (OK) button.
10
Repeat steps 8 and 9 for each fax transmission document if necessary.
11
When scanning all sets of the documents is complete, select [Scan Complete]
and press the (OK) button.
Adjusting the Density (Density)
You can adjust the density in seven levels.
1
Press the (FAX) button on the operator panel.
2
Set a document in the ADF or on the document glass.
3
Press the button to select [Internet Fax] and press the button.
4
Press the or button to select [Scan Setting] and press the button.
5
Press the button to select [Density] and press the button.
6
Press the or button to select the density, and then press the (OK)
button.
[0] is the standard value. To increase the density, select [+1], [+2], or [+3] (darkest). To decrease the density,
select [-1], [-2], or [-3] (lightest).
7
Specify a destination.
Entering a Destination E-mail Address
Specifying a Destination from Address Book/Group List
Selecting a Destination Using One Touch Buttons
Selecting a Destination from Transmission History
Searching for a Destination in the LDAP Server
8
Change other settings if necessary, and then press the (MONO) button.
You can change other settings for fax transmissions.
Setting Scanning for Transmission
Sending a Fax via the Internet
Setting Scanning for Transmission

Oki MC363dnw Specifications

General

Brand	Oki
Model	MC363dnw
Category	All in One Printer
Language	English