Oki MC363dnw Advanced Manual

- 269 -
9. Operating Management/ Specifications
• Default Settings
• Fcode Box
• Security Function
• Other Settings
Fax Setup
Item Factory
default
setting
Description
Resolution Normal Sets the default image quality.
Background Removal Auto Sets the default setting of the background
removal.
Density 0 Sets the default density to scan.
Scan Size A4 or Letter Sets the default scan size.
Continuous Scan(Glass) OFF Sets whether to use Continuous Scan.
Continuous Scan(ADF) OFF
Edge Erase Setting OFF Sets whether to erase the edge shadow
created on Fax scan image.
Width 2 mm (0.1 inch) Sets an erasing width created on Fax scan
image.
TTI ON Sets whether to add the sender's name to the
header of the sent fax by default.
Transmit Confirmation Report OFF or ON Sets whether to automatically print
transmission results by default.
Memory Tx ON Sets whether to use memory transmission
(ON) or real-time transmission (OFF) by
default.
Item Factory
default
setting
Description
Edit / Register Confidential
Box
Box Name (NULL) Sets the name for confidential boxes. You
can enter up to 16 characters.
Sub-Address (NULL) Sets the sub-address for confidential box.
You can enter up to 20 characters.
Hold Time 0 Sets the hold time for confidential box.
Available range: 0 to 31 days
I.D.Code (NULL) Sets the password for confidential box.
Register a 4-digit numerical number only.
Bulletin Box Box Name (NULL) Sets a bulletin box name. You can enter up to
16 characters.
Sub-Address (NULL) Sets the sub-address for bulletin box. You
can enter up to 20 characters.
Delete Deletes an Fcode box.
Item Factory
default
setting
Description
ID Check Tx OFF Sets whether to use the ID check
transmission.
Broadcast Destination ON Sets whether to indicate the transmission
destination number before starting broadcast
transmission.
Confirm Dial OFF Sets whether to reenter the transmission
destination fax number before sending a fax.
Manual Input Enable Sets permission of manual input.
Secure Receive Setting OFF Sets whether to store a received fax in the
memory of this machine without printing
immediately.
Password (NULL) Sets the password that is entered when
printing a received fax image that is stored in
the memory of this machine.
Item Factory
default
setting
Description
Redial Tries 2 times Sets the number of redial attempts.
Available range: 0 to 9 times
Redial Interval 1 minute Sets the time between redial attempts.
Available range: 0 to 5 minutes
Block Junk Fax
List
Setting OFF Sets Block Junk mode Fax.
Registered List Register / Edit (NULL) Register / Edit addresses for Block Junk Fax
when [Mode2] or [Mode3] is set.
Delete Delete addresses for Block Junk Fax when
[Mode2] or [Mode3] is set.
Ring Response 1 Ring Sets the number of rings required before
receiving an incoming fax.
Dialing Pause Duration 2 seconds Sets the dial pause time.
Available range: 0 to 10 seconds
Rx Reduc. Rate Auto Sets the reception reduction rate.
Reduc. Margin 24 mm (0.9
inch) or
100 mm (3.9
inch)
Sets the threshold level of reception
reduction.
Available range: 0 to 100 mm (0 to
3.9 inches)
ECM Mode ON Sets whether to use the error correction
mode.

Oki MC363dnw Specifications

General

Brand	Oki
Model	MC363dnw
Category	All in One Printer
Language	English