- 189 -
5. Fax
You can change other settings for fax transmissions.
Setting Scanning for Transmission
To enable the Scan to Fax Server function, follow the procedure below in Admin Setup.
If the Scan to Fax Server function is enabled, the fax function is disabled.
1
Press the (SETTING) button on the operator panel.
2
Press the button once to select [Admin Setup] and press the button.
3
Enter the administrator password, and then press the (OK) button.
The factory default administrator password is "999999". If the administrator password is changed, enter the
updated password.
4
Press the button to select [FaxServer Function] and press the button.
5
Check that [Environmental Settings] is selected, and then press the button.
6
Check that [FaxServer Function] is selected, and then press the button.
7
Press the or button to select [ON] and press the (OK) button.
8
Check that [Yes] is selected on the confirmation screen, and press the (OK)
button.
The machine automatically restarts.
Enabling the Scan to Fax Server Function
To Next Page
Loading...
Need help?
General
