Issuing a HALT Command via the Front Panel:
1.
Press the POWER menu button to switch the front panel display to the Power
Menu. Verify that you are under the Management sub menu (use the left and right
arrow keys if necessary).
2.
Press DOWN until Halt is highlighted. Press the ENTERbutton in the center of the
keyapd once to activate the halt, and then press it again to confirm your choice in
the confirmation menu to the right.
Once you have halted your VersaSync, power must be removed (unplugged) and reapplied
in order to restart the unit.
4.2 Rebooting the System
To reboot VersaSync via the Web UI:
1.
Navigate to TOOLS > SYSTEM: Reboot/Halt.
2.
Select the Restart after Shutdown box in the Reboot/Halt window.
3.
VersaSync will now be rebooted and be accessible again shortly thereafter.
Rebooting via USB Port, Telnet, SSH, SNMP
With a serial connection to the USB port, telnet connection or SSH connection, type
reboot <Enter> to reboot VersaSync.
Reboot is also is available to be performed through an snmpset operation. For more
information on VersaSync commands, see "CLICommands" on page272.
4.3 Notifications
If an event occurs e.g., VersaSync transitions into Holdover, or a short is detected in the
GNSS antenna, VersaSync can automatically notify users that a specific event has
occurred.
4.2 Rebooting the System
CHAPTER 4 • VersaSync User Manual Rev. 7.0
209
To Next Page
Loading...
Need help?
General