Note: If VersaSync is not connected to a GNSS antenna, this log will remain
empty.
System Log
Displays log entries related to the Timing System events and daemon events (such as the
Alarms, Monitor, Notification, or SNMP daemons starting or stopping, etc.)
Timing Log
Displays log entries related to Input reference state changes (for example, IRIG input is not
considered valid), antenna cable status. Examples include:
GRGR = GNSS Reference
1
antenna fault: The GNSS Antenna Problem alarm
indicates the GNSS receiver has detected an over-current or undercurrent con-
dition (an open or short exists in the GNSS antenna cable, or the GNSS antenna is
not connected to VersaSync). The receiver will attempt to continue the normal
acquisition and tracking process regardless of the antenna status.
GR antenna ok: The antenna coax cable was connected at this time or an open or
short in the antenna cabling was occurring but is no longer being detected.
Update Log
Displays log entries related to software updates that have been performed.
4.6.2.2 The Logs Screen
The Logs Screen provides access to settings that apply to all logs.
To access the Logs Screen:
1.
Navigate to MANAGEMENT > OTHER: Log Configuration.
2.
The Logs screen will appear. It is divided into two panels:
1
GR = GNSS Reference
4.6 Quality Management
CHAPTER 4 • VersaSync User Manual Rev. 7.0
247
To Next Page
Loading...
Need help?
General