EasyManuals Logo
Home>Orolia>Server>VersaSync

Orolia VersaSync User Manual

Orolia VersaSync
378 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #224 background imageLoading...
Page #224 background image
In some situations, two events are generated. One event occurs in the transition to a spe-
cified state and then another event occurs when transitioning back to the original state.
Examples of these are losing sync and then regaining sync, or going into Holdover mode
and then going out of Holdover mode. Other situations may only consist of one event. An
example of this situation is switching from one input reference to another.
Notifications of each event that may occur can be via alarms, via SNMP Traps being sent to
one or more SNMP Managers, via an email being sent to a specified email recipient, or a
combination of the three. The Notifications page allows a user to configure whether the
occurrence of each event automatically triggers an alarm to be generated, an SNMP trap
to be sent out, an email to be sent out, or a combination of the three.
Also, this page allows the desired email recipient’s address for that particular event to be
specified. Each event can be configured with the desired email address that is specific to
just that one event only. Note that only one email address can be specified in each Email
Address field. If desired, the same email address can be used in all of the fields, or different
addresses can be used for different events.
Note: Whether or not notifications are enabled/disabled for a given event,
the occurrence of the event is always logged.
All available VersaSync events that can generate a notification to be sent are located under
different tabs in the Notification Events panel: Timing, GPS, and System.
The VersaSync Events that can automatically trigger a notification are listed in the Event
column. It is possible to:
Mask the alarm generation for specific events (prevent the alarm)
Enable SNMP” (to send out an SNMP trap)
Send an email to the address specified in the corresponding Email Address
column.
4.3.1 Configuring Notifications
To configure Notifications:
1.
Navigate to MANAGEMENT > OTHER: Notifications. The Notifications screen
will display:
210
CHAPTER 4 VersaSync User Manual Rev. 7.0
4.3 Notifications

Table of Contents

Other manuals for Orolia VersaSync

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Orolia VersaSync and is the answer not in the manual?

Orolia VersaSync Specifications

General IconGeneral
BrandOrolia
ModelVersaSync
CategoryServer
LanguageEnglish