the new configuration file. Once powered back up, VersaSync will be configured
with the previously stored file.
4.8.2.5 Restoring the Factory Defaults
For instructions on how to restore the VersaSync's configuration files to their factory
default settings see "Resetting All Configurations to their Factory Defaults" on
page255.
4.8.3 Cleaning the Configuration Files and Halting the System
The "Clean and Halt" procedure restores the configuration files to their factory defaults
and then immediately halts the system, so as to prevent any changes from being applied to
the factory default condition.
To perform a "Clean and Halt":
1.
Navigate to TOOLS > SYSTEM: Upgrade/Backup.
2.
In the Actions panel, click * Clean Configuration and Halt * .
3.
VersaSync restores the configuration files to their factory default, and halts the sys-
tem.
4.8.4 Default and Recommended Configurations
The factory default configuration settings were chosen for ease of initial setup. However,
some of the default settings may deviate from best practices recommendations. The fol-
lowing table outlines the differences between factory default and recommended con-
figuration settings for your consideration:
4.8 Resetting the Unit to Factory Configuration
CHAPTER 4 • VersaSync User Manual Rev. 7.0
261
To Next Page
Loading...
Need help?
General