Changing Signature Control via the Front Panel
The VersaSync front panel allows you to change the signature control between two states:
Output Always Enabled and Output Always Disabled. For more options and control over
the Signature Control setting, you must use the Web UI (see above).
On the unit front panel:
1.
Press the Outputs button.
2.
Select the output you wish to configure.
3.
Use the arrow keys to select ON (enabled) or OFF (disabled). Press the enter key.
4.
In the confirmation menu on the right hand side of the screen, press the enter key
again.
2.8 Configuring Network Settings
Before configuring the network settings, you need to setup access to VersaSync web user
interface ("Web UI"). This can be done by assigning a static IP address, or using a DHCP
address. For more information, see "Assigning a Static IP Address" on page36.
Once you have assigned the IP address, login to the Web UI. For more information, see
"Accessing the WebUI" on page32.
To configure network settings, or monitor your network, navigate to VersaSync's Network
Setup screen.
To access the Network Setup screen:
Navigate to MANAGEMENT > Network Setup. The Network Setup screen is
divided into three panels:
62
CHAPTER 2 • VersaSync User Manual Rev. 7.0
2.8 Configuring Network Settings
To Next Page
Loading...
Need help?
General