l
Use this mode when operating with a glove on.
l
Depending on the type of glove, operation may be ignored.
l
With finger operation, the screen may not respond properly.
[Touch (Water)] mode
l
Use this mode when the screen or finger is wet with water drops in operation.
l
Depending on the water drop condition, operation may be ignored.
l
Operation may not be performed correctly around the edges of the screen.
3. If a confirmation message appears, click [Yes].
NOTE
l
You cannot use the pen regardless of the setting before Windows is started up.
l
You cannot use the pen with the operations other than the Windows (PIN input of Bitlocker, operating screen from Recovery
Drive, etc.) even if the pen operation mode is set.
l
When “Touchscreen Mode” is set to [Touch (Water)], multi touch input is reduced to 3 points.
IMPORTANT
l
Do not touch the screen while switching the operation mode. Switching may fail by doing so.
Calibrating the Screen
When you cannot point correctly with the pen (included) or your fingers, calibrate the screen by following the steps below.
Perform the calibration as an administrator. A standard user needs to perform the calibration as an administrator before performing the calibration for
each user.
NOTE
l
At first, sign in to Windows as an administrator, and perform this calibration.
1.
Click (Start) - [All apps] - [Windows Tools] - [Control Panel] - [Hardware and Sound] - [Tablet PC Settings].
2. Click [Calibrate...].
l
If the “User Account Control” is displayed, click [Yes].
3. Using the pen (included) or finger, touch each of the “+” target marks one by one, and then click [Yes].
NOTE
l
The following message, “Right-click anywhere on the screen to return to the last calibration point. Press the Esc button to
close the tool.” will appear on the center of the screen during calibration. However, the operation to close the tool by pressing
the ≪ Esc≫ key can be performed.
l
If you cannot touch the desired position, perform calibration again and restart the computer.
IMPORTANT
l
If you perform calibration as a standard user, the calibration data is valid until you sign out. (The data becomes invalid after
you have signed out.) When using the computer continuously, perform calibration as an administrator.
l
If you cannot operate the computer correctly after calibration, delete the calibration data by clicking [Control Panel] - [Hard-
ware and Sound] - [Tablet PC Settings] - [Reset...], and perform calibration again. (Be sure to delete the calibration data as an
administrator.)
To Next Page
Loading...
Need help?
General