Bluetooth
<Only for model with Bluetooth>
You can access internet and other Bluetooth devices without connecting cables.
NOTE
l
Communication is established through the Bluetooth antenna (A). Do not block the antenna area with your hand or body.
l
To use Bluetooth, set [Bluetooth] to [Enabled] (default) in the sub-menu of [Wireless Configuration] in the [Advanced] menu of
the Setup Utility.
l
The transmission rate will be lower when a microwave oven is used near by.
l
When you uninstall the Bluetooth Driver, turn Bluetooth off.
Using the Bluetooth Function
Before using a Bluetooth, turn the Bluetooth communication on.
Turning on/off the Bluetooth communication
1.
To enable the wireless communication. ( Disabling/Enabling Wireless Communication)
2.
Click (Start) - [Settings] - [Network & internet] - [Airplane mode], and set “Airplane mode” to [Off].
3. To turn off the Bluetooth communication, set “Bluetooth” to [Off].
To turn on the Bluetooth communication, set “Bluetooth” to [On].
Checking the Bluetooth communication status
1.
Click (Start) - [Settings] - [Bluetooth & devices] - [Devices].
NOTE
l
You can also clicking on the taskbar corner, and then click (Bluetooth Devices) - [Show Bluetooth Devices] to
check the communication status.
To Next Page
Loading...
Need help?
General