Battery Power
Battery Indicator
Battery indicator (situation in use): (A) and (B)
*1
Battery indicator (situ-
ation in use)
Battery status
Not lit
l
The battery pack is not inserted or not being charged.
l
Concealed mode is set to ON.
Orange Charging is in progress.
If [Battery Charging Indicator] in the [Main] menu of the Setup Utility is set to [Flashing], the indicator will alternately
become lighter and darker (Flashing).
Green The battery is fully-charged.
Blinking green In order to stop the battery from deteriorating, power supply from another battery or AC adaptor has been shut off,
and the battery power is being consumed.
Do not remove the battery pack in this status.
Red The remaining battery is approximately 9 % or less.
Blinking red The battery pack or the charging circuit is not operating properly. Remove the battery pack immediately.
Blinking orange The battery cannot be charged temporarily due to the following reasons:
l
Its internal temperature is out of the acceptable range.
l
The power supply is not enough because software applications or peripheral devices are consuming a large
amount of power.
l
When charging the computer using USB Power Delivery. The power of the connected USB Power Delivery-
compatible device is insufficient.
Blinking green and
orange alternately
The temperature is low and the computer is warming up to prevent the flash memory drive from malfunctioning. The
computer will start automatically after warming-up.
Blinking orange slowly When you set [Battery Charging Indicator] to [Flashing] on the [Main] menu of Setup Utility.
Battery indicator (replacing status): (C) and (D)
*1
<Only for model with second battery pack>
To Next Page
Loading...
Need help?
General