Wireless LAN
<Only for model with wireless LAN>
Using the wireless LAN allows for the use of network without cable connection.
IMPORTANT
l
Do not use wireless LAN on airplanes, in hospitals, or in other locations where wireless LAN signals may affect devices.
Follow the instructions of airline companies and hospitals. If you use the computer in these locations, turn off the wireless LAN.
l
To avoid unauthorized access to the computer through wireless LAN.
We recommend you to make security settings such as encryption before using wireless LAN.
Otherwise the disk data such as the shared files can be exposed to the risk of unauthorized access.
NOTE
l
Communication is established through the wireless LAN antenna (A). Do not block the antenna area with your hand or body.
l
When you connect this computer to a port replicator compatible with external antenna, you can switch the internal antenna to
the external antenna, or vice versa.
l
The transmission rate will be lower when a microwave oven is used near by.
l
To use wireless LAN, set [Wireless LAN] to [Enabled] (default) in the sub-menu of [Wireless Configuration] in the [Advanced]
menu of the Setup Utility.
Using the Wireless LAN Function
Before using a wireless LAN, turn the wireless LAN communication on.
Turning on/off the wireless LAN communication
1.
To enable the wireless communication. ( Disabling/Enabling Wireless Communication)
Setting the wireless LAN access point
Preparation
Follow the instruction manual of the wireless LAN access point to make settings for the access point to recognize the computer.
1.
Click on the taskbar corner.
2.
Click to turn the wireless LAN on.
To Next Page
Loading...
Need help?
General