Using a Polycom Touch Control Device
Polycom, Inc. 89
Download and Install People+Content IP
You need to download and install the People+Content IP application on a computer before you can use it
to show content.
1 On a computer, go to the Polycom People+Content IP page.
2 Under Resources, download the People+Content IP software for Mac or PC.
3 Extract the contents of the .zip file and launch the installer. Follow the instructions in the installation
wizard.
Share Content with People+Content IP
People+Content IP allows you to send content from a computer that is connected directly to a Polycom
Touch Control.
1 Using the USB content cable, connect the computer directly to the underside of the Touch Control.
If autorun is enabled on the computer, you are prompted to run People+Content IP. If autorun is
disabled on your computer, People+Content IP shows up as an external drive, and you must navigate
to My Computer to launch it manually.
2 Launch People+Content IP.
3 In People+Content IP, open the content you want to show and click .
4 To stop showing content, click .
Stop Sharing Content with People+Content IP
When you are done showing content, shut down People+Content IP.
» Click in the People+Content IP application.
Share Content from a USB Drive
A Polycom Touch Control can show content stored on a USB drive.
1 Connect the USB device to the USB port on the right side of the Polycom Touch Control.
To Next Page
Loading...
Need help?
General
