Polycom realpresence group series User Manual

Using a Polycom Touch Control Device
Polycom, Inc. 95
3 Under Meetings, touch Mute Auto Answer Calls to enable the option.
4 After the call connects, touch Mute when you're ready to unmute the microphones.
Temporarily Refuse Calls
If your system administrator has allowed you access, you can automatically refuse incoming calls when you
do not want to be disturbed.
Callers get a message that the call was rejected, and you receive no notification about incoming calls. You
can, however, make outgoing calls.
TASK
1 From the Home screen, touch .
2 Touch the RealPresence Group Series System tab.
3 Set Auto Answer Point-to-Point or Auto Answer Multipoint Video to Do Not Disturb.
Cameras
You can adjust available cameras in several ways.
Select a Camera
You can use the Polycom Touch Control to select and adjust the main camera or other near-end or far-end
video sources.
You might be able to adjust other auxiliary cameras or far-end cameras that support pan, tilt, and zoom
movement.
When you are in camera control mode, you can press and hold a number to save a preset.
TASK
1 From the Call screen or from the Home screen, touch Cameras.
2 Touch Select Camera, and then touch the camera or other video source you want to use.
3 In a call, touch Cameras > Near or Far to select either near-end or far-end control.
The video source is shown to the call participants.
Adjust Cameras
After you select a camera, you can make some adjustments to enhance the view.
Note: Before you can adjust the EagleEye Director, you must turn camera tracking off.
TASK
1 Touch Cameras > Control Camera.
2 Touch the arrow buttons on the Polycom Touch Control to move the camera up, down, left, or right.
3 Touch and to zoom out and zoom in.

Polycom realpresence group series Specifications

General

Brand	Polycom
Model	realpresence group series
Category	Conference System
Language	English