Channels 1 to 11
• When using IEEE 802.11 a:
Channels 36,40,44,48
9. Press the [Menu] key to return to the initial screen.
10. Print a configuration page to confirm the settings.
• For details, see Web Image Monitor Help, and "Using Web Image Monitor", Software Guide.
•
For details about printing the configuration page, see p.44 "Test Printing".
Setting the SSID
When [Communication Mode] is set to [Infrastructure Mode] or [802.11 Ad-hoc Mode], you must specify
the Service Set Identifier (SSID) of the wireless access point that the printer will connect to for network
access.
Ask your network administrator for the SSID to use.
1. In
the [Wireless LAN] menu, press the [
] or [ ] key to select [SSID Setting], and then press
the [OK] key.
If an SSID has been set, you can check the current SSID setting.
2. Press [SSID], and then press [Enter].
3. Enter the characters, and then press the [OK] key.
You can switch among lower /upper cases and numeric characters by pressing [ab/AB/12].
The characters that can be used are ASCII 0 × 20-0 × 7e (32 bytes).
5. Configuration
86
To Next Page
Loading...
Need help?
General