Installing the Printer Driver Using Parallel Cable
This describes how to install the PCL or PostScript 3 printer driver when using a parallel port.
To use a printer connected using a parallel interface, click [LPT1] when installing the printer driver.
• Manage Printers permission is required to install the drivers. Log on as an Administrators group
member.
Installing the PCL Printer Driver
This describes how to install the PCL printer driver when using a parallel port.
1. Close all applications except this manual.
2. Insert the CD-ROM into the CD-ROM drive.
The installer starts.
Auto
Run may not work with certain operating system settings. If this happens, launch "Setup.exe" on
the CD-ROM root directory.
3. Select an interface language, and then click [OK].
The default interface language is English.
4. Click [PCL Printer Drivers].
The software license agreement appears in the [License Agreement] window.
5. After reading the agreement, select the [I accept the agreement.] check box, and then click
[Next].
6. Select the printer driver you want to use in the [Select Program] window.
You can select several printer drivers.
The PCL 6 printer driver is installed in the language specified by your operating system.
7. Click [Next].
8. Select the check box of the printer model you want to use.
The printer name can be changed in the [Change settings for 'Printer Name'] box.
9. Double-click the printer name to display the printer settings.
The details shown in [Comment], [Driver], and [Port] vary depending on the operating system, printer
model, and port.
10. Check that [LPT1:] is shown in [Port].
11. Configure the user code, default printer, and shared printer as necessary.
12. Click [Continue].
3. Local Connection
40
To Next Page
Loading...
Need help?
General