Setting the SSL/TLS encryption mode
This can be specified by the network administrator.
After installing the device certificate, specify the SSL/TLS encrypted communication mode. By making this
setting, you can change the security level.
For details about logging in and out with administrator authentication, see p.22 "Using Web Image
Monitor to Configure Administrator Authentication".
1. Log in to Web Image Monitor as an administrator.
2. Click [Configuration] in the Menu area.
3. Click [SSL/TLS] in the "Security" category.
4. Select the encryption communication mode in the "Permit SSL/TLS Communication" list, and
then click [OK].
Select [Ciphertext Only], [Ciphertext Priority], or [Ciphertext/Cleartext] as the encrypted
communication mode.
5. Click [OK].
6. Click [Logout].
7. Close Web Image Monitor.
• The SSL/TLS encrypted communication mode can also be specified using Web Image Monitor. For
details, see Web Image Monitor Help.
SNMPv3 Encryption
This can be specified by the network administrator.
When using SmartDeviceMonitor for Admin or another application to make various settings, you can
encrypt the data transmitted.
By making this setting, you can protect data from being tampered with.
For details about logging in and out with administrator authentication, see p.22 "Using Web Image
Monitor to Configure Administrator Authentication".
1. Log in to Web Image Monitor as an administrator.
2. Click [Configuration] in the Menu area.
3. Click [Network Security] in the "Security" category.
4. Click
[Encryption Only] in the "Permit SNMPv3 Communication" area of the "SNMP" section,
and then click [OK].
5. Click [OK].
6. Click [Logout].
7. Enhanced Network Security
100
To Next Page
Loading...
Need help?
General