msh> ipp auth {basic|digest|off}
• User authorization settings are "basic" and "digest".
• Use "off" to remove a user's authorization.
• If user authorization is specified, register a user name. You can register up to 10 users.
IPP user configuration
Configure IPP users according to the following messages:
msh> ipp user
The following message appears:
msh> Input user number (1 to 10):
Enter the number, user name, and password.
msh> IPP user name:user1
msh> IPP password:*******
After configuring the settings, the following message appears:
User configuration changed.
ipv6
Use the "ipv6" command to display and configure the IPv6 settings.
View setting
msh> ipv6
IPv6 stateless address
msh> ipv6 stateless {on|off}
If "on" is selected, IPv6 requests information required for maintaining stateful connection to the router
for as long as the printer power is turned on. This setting allows information from the router to be
obtained constantly, and periodically refreshes the effective period of the stateless address.
logout
Use the "logout" command to save the changes and quit telnet.
Quit telnet
msh> logout
A confirmation message appears.
{yes|no|return}
Enter [yes], [no] or [return] by typing the word, and then press the [Enter] key.
Using telnet
55
To Next Page
Loading...
Need help?
General